HOME SOLUTION CASES SOLUTION OF WING BEND

SOLUTION CASES

SOLUTION OF WING BEND

We can resolve various problem of V die such a mark less, reduction of preparation time, near hole bending.

PROBLEM
Reduction of preparation time of V die

SOLUTION
We are able to reduce annual preparation time approximately 60% by introducing the wing bend that the range of the plate thickness that we could process was wide.


PROBLEM
I want to reduce amount of possession die(V die)

SOLUTION
We covered all several kinds of V dies in one and was able to reduce the amount of the possession die to broadcloth by introducing the wing bend which did not need a spare die for abrasion again.


PROBLEM
I want to reduce an abrasion expense of die (V die)

SOLUTION
An abrasion expense disappeared by introducing the wing bend which did not need abrasion.


PROBLEM
I want to use a die superior in the durability

SOLUTION
Abrasion was controlled than a conventional die by introducing a wing bend plus of the structure that work (board) and the die surface did not come in contact with directly, and the durability improved it.


PROBLEM
I want to get rid mark trace of a of die(V die)

SOLUTION
There was not mark trace at all when I bent it in a wing bend of the structure unlike the V die.


PROBLEM
I want to do good processing of the precision without bending it, and attaching a woundand the huskiness trace

SOLUTION
The precision is good by the die surface does not come in contact with work (plate) directly and introducing the wing bend plus that there is not of the interposition of the elastic body in the meantime; there is not mark at all.


PROBLEM
I want to bend SUS and Aluminum plate without a protection sheet

SOLUTION
Even if there is not a protection sheet by introducing a Wing Bend Plus, there is not the wound at all; was able to process it.


PROBLEM
I want to bend it at near hole without transforming it

SOLUTION
We are able to bend it at near hole without transforming by introducing a Wing Bend with a little elongation and mark less.


PROBLEM
I want to reduce swelling of the hypotenuse bending

SOLUTION
It was possible for hypotenuse bending of a little swelling by introducing the Wing Bend that there was little growth to greatly influence the transformation of the corner part of the oblique side bending.


PROBLEM
I want to do the short flange processing with beautiful.

SOLUTION
It was possible for the flange processing that was beautiful, and had a short it by distance equivalent to the V width of the V die was short and introducing a wing bend with a little growth.


PROBLEM
I want to let the worker learn a sheet metal technology in a short term

SOLUTION
We were able to shorten the acquisition period of the sheet metal technology by introducing the unnecessary wing bend plus that a thing educated the "choice method "choice method "choice, usage of the prevention of wound tool" of the bending one" of small V width" that was an important sheet metal technology finely.

HOME | Site usage agreement | Privacy policy
CATALOGUE DOWNLOAD | ACCESS

PAGE TOP